alloymap.Ounce Works ↗

Back to AlloyMap

3003

AA 3003 | Wrought alloy; product form and temper not specified for composition

Each value is checked in at least three authoritative issuer publications. Some issuers reproduce a shared standard; these are not independent experiments. Do not use as certified design allowables. View sources ↗

No reviewed mechanical claim for this record.

Chemical composition

Only reviewed weight-percent bounds are listed. A blank bound means only the other threshold was reported.

Element / source labelMinimum wt%Upper wt%
Si—0.6
Fe—0.7
Cu0.050.2
Mn1.01.5
Zn—0.1
Others (each)—0.05
Others (total)—0.15

AA registered 3003 composition limits in wt.% corroborated by Elisental EN AW-3003 wire and Alumeco EN AW 3003 rolled-product supplier tables. These are three issuer publications of specification limits, not independent chemical analyses or separately acquired EN standards. Only seven mutually corroborated numeric fields are registered. Alumeco also prints a Ti limit, but it was not included in the seven previously cross-checked fields; blank Mg/Cr cells are not zero. Aluminum is remainder without an invented numeric minimum. Mechanical and physical properties remain source- and condition-specific candidates.

Physical and thermal properties

PropertyReported valueUnitCondition
No reviewed physical or thermal claim for this record.

Evidence

Teal Sheets, December 2025 — The Aluminum Association

EN AW 3003 Rolled Products, Data Sheet — Alumeco A/S

Aluminium wire EN AW-3003, short version, Rev. 0326 — Drahtwerk Elisental W. Erdmann GmbH & Co.

Show the exact source location for each value

Official issuer page