alloymap.Ounce Works ↗

Back to AlloyMap

5050

AA 5050 | Wrought alloy; product form and temper not specified for composition

Each value is checked in at least three authoritative issuer publications. Some issuers reproduce a shared standard; these are not independent experiments. Do not use as certified design allowables. View sources ↗

No reviewed mechanical claim for this record.

Chemical composition

Only reviewed weight-percent bounds are listed. A blank bound means only the other threshold was reported.

Element / source labelMinimum wt%Upper wt%
Si—0.4
Fe—0.7
Cu—0.2
Mn—0.1
Mg1.11.8
Cr—0.1
Zn—0.25
Others (each)—0.05
Others (total)—0.15

Exact AA 5050 registered wt.% composition limits match the Elisental EN AW-5050 wire and Bronmetal EN AW-5050 rolled-product issuer tables. These are three publications of specification limits, not independent chemical assays or delivered-product measurements; both supplier tables cite or restate European designation limits. Single upper numbers are maxima. AA footnote 3 defines Others (total) as the sum of other metallic elements at least 0.010 wt.% each, rounded as specified. Ti has no stated numeric limit; Al is remainder, not a calculated numeric minimum. 5050A/C/D are distinct designations. Wire mechanical properties remain unpublished pending independent condition-specific review.

Physical and thermal properties

PropertyReported valueUnitCondition
No reviewed physical or thermal claim for this record.

Evidence

Teal Sheets, December 2025 — The Aluminum Association

Aluminium laminate - Alloys — Bronmetal

Aluminium wire EN AW-5050, short version, Rev. 0326 — Drahtwerk Elisental W. Erdmann GmbH & Co.

Show the exact source location for each value

Official issuer page