alloymap.Ounce Works ↗

Back to AlloyMap

6060

AA 6060 | Wrought alloy; product form and temper not specified for composition

Each value is checked in at least three authoritative issuer publications. Some issuers reproduce a shared standard; these are not independent experiments. Do not use as certified design allowables. View sources ↗

No reviewed mechanical claim for this record.

Chemical composition

Only reviewed weight-percent bounds are listed. A blank bound means only the other threshold was reported.

Element / source labelMinimum wt%Upper wt%
Si0.30.6
Fe0.10.3
Cu—0.1
Mn—0.1
Mg0.350.6
Cr—0.05
Zn—0.15
Ti—0.1
Others (each)—0.05
Others (total)—0.15

AA registered 6060 wt.% specification limits are corroborated by Anodall EN AW-6060 extrusion and Elisental EN AW-6060 wire publications. They are three issuer publications of standards-based limits, not independent chemical assays. Single upper values are maxima; Al is remainder, not an invented minimum. Product mechanical, thermal and physical values remain unpublished pending condition-level review.

Physical and thermal properties

PropertyReported valueUnitCondition
No reviewed physical or thermal claim for this record.

Evidence

Teal Sheets, December 2025 — The Aluminum Association

Anodall ALLOY EN AW 6060 technical sheet — Anodall Extrusion S.p.A.

Aluminium wire EN AW-6060, short version, Rev. 0326 — Drahtwerk Elisental W. Erdmann GmbH & Co.

Show the exact source location for each value

Official issuer page