alloymap.EnglishOunce Works ↗

AlloyMap 홈으로

2024

AA 2024 | 가공용 합금; 조성에 대해 제품 형태와 질별이 명시되지 않음

모든 값은 공신력 있는 발행기관 3곳 이상의 문서에서 확인했습니다. 일부 발행기관은 같은 표준을 그대로 옮겨 싣기 때문에, 이 값들은 서로 독립된 시험이 아닙니다. 인증된 설계 허용값으로 사용하지 마세요. 출처 보기 ↗

출처 문서의 제목과 조건 설명은 출처 언어 그대로, 공정 항목의 값·보류 사유·검토 메모는 영어 그대로 표시하며 번역하지 않습니다. 숫자, 단위, 질별, 합금 지정도 번역하지 않습니다.

이 기록에는 검토를 마친 기계적 물성 값이 없습니다.

화학 조성

검토를 마친 질량 백분율(wt%) 한계만 표시합니다. 비어 있는 한계는 다른 쪽 한계만 보고되었다는 뜻입니다.

원소 / 출처 표기하한 wt%상한 wt%
Si—0.5
Fe—0.5
Cu3.84.9
Mn0.30.9
Mg1.21.8
Cr—0.1
Zn—0.25
Ti—0.15
Others (each)—0.05
Others (total)—0.15

AA registered 2024 wt.% composition limits confirmed by BIKAR EN AW-2024 supplier tables and United Aluminum's AA-attributed technical manual. These are three issuer publications of specification limits, not independent chemical measurements. Single numbers are inclusive maxima; unshown minima are unspecified. Al is remainder without an invented numeric limit. AA Teal footnote 7 (printed p. 18 / PDF p. 24) and BIKAR p. 1 permit Zr+Ti maximum 0.20 wt.% only for forged or extruded product by mutual supplier/producer and purchaser agreement; this optional condition is not a general published 2024 limit. Research corrosion data and supplier physical/mechanical values remain unpublished pending separate condition-level review.

물리·열 물성

물성보고된 값단위조건
이 기록에는 검토를 마친 물리·열 물성 값이 없습니다.

근거

Teal Sheets, December 2025 — The Aluminum Association

EN AW-2024 alloy data sheet — BIKAR METALS GmbH

United Aluminum Technical Manual 2022 — United Aluminum Corporation

값마다 정확한 출처 위치 보기

공식 발행기관 페이지